How to choose the right armrest

1. Material

Stainless steel material is better. Plastic or rubber coating is also available. The wall thickness of the steel pipe should be 1.2mm or more. A single base fixing point can be fixed with four screws. These requirements can be communicated with the seller in advance and let him recommend the right one. of. (Do not choose PVC. Plastic steel material, the strength is not enough. Iron is easy to corrode) It is not necessary to buy a big brand, but the quality must not be sloppy, and the safety is greater than the sky.

2. How to install it firmly and beautifully

Buy the anti-collision hospital handrail, if you ask the master to install it, you must pay attention to the installation details and perforate the wall. If it is full tile, use a glass drill to penetrate the tile first, and then use an impact drill to deepen it, if it is half tile, use it Turn the diamond drill or electric hammer to the electric switch position, use the drill bit to grind through the wall tiles and then deepen it. (This is troublesome, but it will not damage the finished brick. If the master uses an electric hammer to punch directly, it is a violent construction, which will easily damage the surface of the brick and cause the brick to break.) The expansion pipe or expansion wire fixing screws must be tightened very tightly. None of the screws can be loosened. Some brackets need to be fixed on the ground. Try not to perforate the ground. A good nail-free glue can bond very firmly. Horizontal and vertical are the minimum requirements, but some handrails against the wall can also be worn diagonally.

3. Installation size and location

A single-layer armrest is installed on the toilet. The height is better for the elderly to sit on the toilet, with their elbows hanging naturally on the armrests. The height of the elderly is different, so the installation is lower. If it is a double-layer standing handrail, the lower handrail should be 650mm___750mm above the ground. Also pay attention to the spacing. The distance between the two armrests should be adjusted according to the size of the elderly. The elbows should be naturally lowered and placed in the middle of the armrests. The basic size is between 500mm and 650mm. The shower armrests should be worn obliquely, with an angle of 30 degrees-45 degrees, and a height of 1100mm__1200mm. If the home is squatting, such as installing a single-sided armrest, install it on the right hand side, and set the height (considering the sitting stool) to be about 700mm, and it can also be installed at an oblique angle.