What to pay attention to when installing the shower curtain rod

The installation height of the shower curtain rod, that is, the height of the shower curtain hem above the ground, should be 1-2 cm. The hem is better not to mop the floor, it is easy to get dirty, and sometimes it is easy to tear the shower curtain if you accidentally step on it. The height of the shower curtain rod determines the height of the shower curtain. When buying a shower curtain, first determine the width and height of the shower curtain according to the size of the shower area. The height of shower curtains on the market is mostly 180 cm, which is enough, there is no need to buy 2 meters high. At present, the installation method of the telescopic shower curtain rod is divided into three types according to the length of the shower curtain rod: full spring, fine adjustment spring, and fine adjustment. Among them, the fine adjustment spring method is more common, and the simple fine adjustment method has gradually been eliminated due to poor rigidity. Because the full spring method does not require fine adjustment and is relatively simple to install, it is more suitable for buyers who use telescopic shower curtain rods for the first time. It is worth noting that the quality of plastic parts such as telescopic shower curtain rod heads and fine-tuning buttons is very important. The two ends of the head should be made of ABS engineering rubber, which is relatively solid. If the contact between the head and the wall is made of elastic plastic, add With the three-dimensional pattern design on the upper surface, it will be easier to fit the wall, and it will be easier and firmer to install :) As for the fine-tuning button, first of all, it is necessary to facilitate manual adjustment. This is the key to firm installation. The handle with handle or gear is obvious. Some adjustments are more effective. Now there are spring screws, which will pop up a short section when rotating, and it is very easy to stand against the wall immediately. Straight rods are all installation-free telescopic tubes. When you rotate the rod to about 5cm more than the width of the actual wall, it is better to tighten the rod to the place where it needs to be installed. (For example, the width of the bathroom pole to be installed in your bathroom is 1.4 meters. Then you rotate the pole to a height of 1.45 meters to the position where you need to install it. If it is easy to go up, then take it down and extend it a little. If it is still very easy at 1 meter 46, then extend some more and so on to know that the pole can not be pushed up, and then install it by shortening it a little bit just to be able to go up. In addition, after installation, do not rotate the pipe to make the pole. Become loose :). At present, only U-shaped combination rods and curved rods are required for tool installation. About the principle and advantages of straight pole installation Straight rods are all spring-structured. Inside the bath rod is a very thick spring, which is installed against the pressure of the wall facing the spring and the spring's supporting force. The advantage is that there is no need to punch holes to install and damage the wall surface, and it can be removed and installed any number of times. Compared with the inner lock structure, the inner lock structure is locked by the butterfly piece inside. The butterfly piece is made of plastic material, and it is easy to deteriorate due to twisting several times. Telescopic shower curtain rod is a must-have for the ideal home. You can choose according to your favorite.